JAULA DE LANZAMIENTO REF. 1AT01005
JAULA ESTRUCTURA REF. 1AT01005
JAULA DIBUJO
REF. 1AT01005
Launch cage developed by ANTUCO & EMD, manufactured in our facilities. The design of this cage model is carried out under current regulations of the INTERNATIONAL FEDERATION OF ATHLETICS
The throwing cages, with horseshoe-shaped, are made up of the following parts:
10 posts and front doors, made of galvanized 90 x 90 x 3 mm profile. The 10 posts are:
6 Posts that form the rounded part of the horseshoe. They have a height of 7.30 m plus an extension of 640 mm, which is the part to be anchored into the ground. They have a reinforcement profile to increase their resistance.
4 posts of 10.20 m that are placed in the front area of the horseshoe, reinforced with an additional profile to give strength to the set against the forces of the wind.
2 Folding doors, of 10 meters high, made of galvanized steel 80 x 80 x 3 mm profile. To increase their rigidity, they have intermediate crossbars to give strength to them. The doors sit on a lower wheeled trolley, which helps to support the set and to facilitate its movements. The doors have 4 hinges, which together with the use of the undercarriage, to avoid deforming over time.
4 stiffeners for the 10.20 m posts.
11 adjustable locks between posts.
2 movable front doors 2 x 10 m.
Intermediate crossbars, between the different 7.30 and 10.20 m posts, to keep the entire cage together thus remaining solidly installed.
5mm single net, 45mm mesh in GREEN polyamide
BACK
